Jump to content

Recommended Posts

I forgot something last time I went on a detecting trip, NOT any more.

Heres a chest 19 high 22 wide and 40 long. Used 11/32nds Ply for the chest and 5mm for the shelfs to ensure lightweight.

The top of it is just shy of 8 inches deep and has a holder for your control box, and plenty of room for everything you can throw at it.

Earphones,X-tra earphones, battery vest, Li-ion batt pack, regular full sized batterys, chargers, straps, bungees, scoops, x-tra parts, whatever you can think of theres plenty of room in the top compartment. I could even make another pre-cut groove for a VLF detector to fit on top.

The bottom has 2 side doors that snap into place letting you access from either side the 2 shelfs each 5 inches high to insure theres no pressure on the cable fitting where it exits the coil, 21 1/2 wide and 39 1/2 long allows you to slide in coils from both sides with non-skid rubber base. These 2 areas allow you to place more coils with the shafts on them than "Carter has Liver Pills" :P I have a 12x24 UFO, 8x15 elliptical, 11 round DD, 11 round mono, 8 mono all with shafts on them ready to pull out and use, and guess what theres ROOM for MORE in there. I build this with the capability of housing a 20 inch round coil also it fits with room for more. Just need to install a couple handles on the outside now. NO MORE S#!T ALL OVER THE PLACE. Now its all in 1 place.

It can go in the back seat of the pick-up or the bed or back of the SUV and when at home , NICE, ALL my stuff is in 1 place.

Maybe I gave some of you serious detectorists an ANSWER to the S#!T all over the place SYNDROME :rolleyes:












Link to post
Share on other sites

Nice detector packer box Frank ! Im working on one for the rear rack of my 06 Arctic Cat Atv. Ill post some Pics when its done....Cant do nuthin else up here in frozen Montana right now anyway. B)

Link to post
Share on other sites

I found a used plastic gun case at a yard sale ,$8 .it even has foam inserts worked perfect .all I had to do was take the shaft apart to get it to fit . slide it back on and ready to go . can mount on a 4 wheeler rack ..

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...